Shengyong Machinery Enameling Machine: Solves problems such as ultra-fine polyurethane enameled wire and round copper wire

The enameling machine is used for making enameled wires, which is to coat insulation paint on the surface of conductors (such as copper or aluminum), dry them, and form enameled wires. If you have any questions about enameled wire and come to consult us, we won't provide too much analysis here. Because today we are going to explain to you some precautions related to ultra-fine polyurethane enameled wire and round copper wire:

1. Ultra fine polyurethane enameled round copper wire (UEM) has excellent direct solderability, allowing customers to weld directly without affecting conductivity without removing the insulation layer. Composite coated polyurethane enameled round copper wire not only has the above properties, but can also be automatically bonded and formed under hot air or solvent conditions, making it very convenient for customers to use.

2. After the goods arrive at the customer, under normal storage and use conditions, the quality validity period of single coated enameled wire is 18 months, and the quality validity period of composite coated enameled wire is 6 months.

3. To be used within the validity period of enameled wire products, products beyond the validity period cannot be reliably guaranteed for quality.

4. The product should be stored indoors, with an indoor temperature of 10 ℃~30 ℃ and a relative humidity not exceeding 70%. The storage environment should not be corrosive gases that are harmful to the product. Unused enameled wires should be placed in their original packaging for protection to avoid compromising product performance.

5. Do not touch the surface of the enameled wire directly with your hands, let alone damage it to avoid affecting its performance.

6. When taking the wire reel by hand, only the outer edge of the reel can be held, be careful not to scratch the surface of the wire with your fingernails.

7. Before use, touch the outer edge of the wire reel by hand to ensure it is smooth and free of burrs, otherwise the wire will be broken during wiring.

8. If the surface of the enameled wire is accidentally bumped or has multiple wire ends during use, this part can be broken with a blade and wound off until there is only one wire end in the entire coil, and it can be used normally.

If you have time, why not stop what you are doing and carefully read the above instructions? You can also take a break and adjust your physical and mental state. Reading the above instructions well may bring convenience to your work, avoid and reduce some unnecessary troubles. Finally, I remind everyone to use enameled wire within its validity period! This article is reprinted from Shengyong Machinery Lacquering Machine: http://www.sdyc.com.cn